Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 153)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM OPERATION / 145
SYSTEM INFORMATION AND DIAGNOSTICS
In order to view the following information and diagnostics screens, the
master switch must be set to the OFF position.
ACCUMULATORS/SEED COUNT/DISTANCE
SCREEN
The Accumulators/Seed Count/Distance screen displays the amount of time
the system has been on, the amount of time and area application control
has occurred, and the distance traveled. Data on this screen is for display
purposes only - it cannot be edited.
Press the Accumulators button to access the Accumulators/Seed Count/
Distance screen.
Figure 88
Accumulators/Seed Count/Distance Screen
NOTE: The Master Switch must be set
to the OFF position to display
the Accumulators/Seed
Count/Distance screen.
POWERED ON TIME
Powered On Time is the accumulated time, in hours, that the system has
been powered ON. Powered On Time accumulates regardless of the mode
of operation - whether it is in SETUP/CONFIGURATION mode or
OPERATE mode. Powered On Time cannot be reset.
SYSTEM ACTIVE TIME
System Active Time is the accumulated time, in hours, that the machine has
actively been controlling. System Active Time accumulates whenever seeds
are detected on at least one sensor. Planting time does not accumulate
during an ALL ROWS FAILED condition. System Active Time can be reset
by pressing the Reset Time button.