Operator’s manual, Auto sort and auto config examples, 98 / system configuration – Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 User Manual
Page 106: Figure 58 auto sort examples
OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
98 / SYSTEM CONFIGURATION
IMPORTANT: Double check each sensor configuration to verify
correct numbering. RPM sensors must be configured
manually.
IMPORTANT: All sensors must be connected to the harnessing in the
correct sequence for AUTO CONFIG to operate properly.
Refer to the Installation Instructions accompanying each
module for correct installation.
To run Auto Config:
1. Press the Auto Config button. An hour glass appears in the upper
right corner while the system is being configured.
AUTO SORT AND AUTO CONFIG EXAMPLES
Figure 58
Auto Sort Examples
10245
10038
5000
10037
5001
10036
WSMT - PDC
WSMB - 18R
POM
WSMB - 18R
POM
WSMB - 18R
3
4
5
6
10245
10036
10037
10038
5000
5001
WSMT - PDC
WSMB - 18R
POM
WSMB - 18R
POM
WSMB - 18R
3
4
5
6
10245
10036
10037
10038
5000
5001
WSMT - PDC
WSMB - 18R
POM
WSMB - 18R
POM
WSMB - 18R
3
4
5
6
Before Auto Sort
After Auto Sort
Move WSMT after Auto Sort
Manually move
WSMT to
correspond with its
actual mounting
location.