System overview, Operator’s manual, Virtual terminal (vt) – Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 User Manual
Page 11
OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM OVERVIEW / 3
SYSTEM OVERVIEW
The DICKEY-john IntelliAg Planter Drill Control system controls planting,
liquid, and granular applications. The IntelliAg is designed to ISO 11783
CAN communication standards providing the capability of communicating
with other manufacturer’s ISO 11783-compatible equipment.
The IntelliAg consists of:
• 5” Virtual Terminal or a 10” Virtual Terminal
• Master Switch
• Working Set Master Module
• Up to 11 Working Set Member Modules (monitors up to a total of 214
rows of seed input) (optional)
• Implement Lift (optional)
• CAN Terminators
• TECU (10” VT only)
• Video Surveillance (10” VT only)
All of the devices communicate using the ISO 11783 CAN communications
standard. System components are described in the following section.
NOTE: Examples shown throughout
this manual depict display
screens of the 10” Virtual
Terminal display.
VIRTUAL TERMINAL (VT)
A 5” or 10” Virtual Terminal provides user interface with the IntelliAg system
used for output and input of data. Reference the VT operator’s manual for
setup and configuration instructions.
Figure 1
5” or 10” Virtual Terminal