Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 12)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
4 / SYSTEM OVERVIEW
MASTER SWITCH
Figure 2
Master Switch
The Master Switch starts and stops product application through a single
switch. The two switch positions are ON and OFF. The normal operating
position for field application is ON. In this position, ground speed controls
the application rate. When ground speed is reduced to zero, all application
ceases. The OFF position inhibits all product flow. When set to the OFF
position, the system shuts off for safety and travel purposes. Setup and
configuration of the system is accomplished when the Master Switch is in
the OFF position. The Master Switch is also housed inside the cab of the
tractor.
WORKING SET MASTER (WSMT) MODULE PDC
(PLANTER DRILL CONTROL)
Figure 3
Working Set Master Module
The Working Set Master (WSMT) module houses the system’s primary
interface device. All system parameters, constants and memory are stored
in the WSMT. The WSMT has four channels for planter, granular seeding,
granular fertilizer, liquid control or RPM. In addition, the WSMT can accept
inputs from 1 hopper level, 1 RPM or pressure sensor, 1 lift switch, 1 ground
speed sensor and up to 16 seed sensors. The WSMT module uses a 48-pin
connector with a jackscrew to secure the connector to the module. The
WSMT is typically mounted on the implement.
6.80”
7.0”
7.45”
3.93”