Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 41)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM CONFIGURATION / 33
CONTROL CHANNEL AND MATERIAL SELECTION
Channels 1 through 4 located at the top of the Control Setup screen
identifies the current material assigned to a specific channel. If more than
one material is configured for a channel, the control channel’s material will
appear in a yellow highlight box.
To change a control channel material:
1. From the Control Setup screen, press the Material Selection box for
the control channel ( Figure 21 ).
2. Use the left and right arrows to scroll through available materials.
3. Press the check mark to select the new material or ‘X’ to cancel.
4. The material appears on the Control Setup screen as the active
material.
If there is only one material or control type established that channel’s
material is not selectable from the Control Setup screen.
Channel/Material Assignment is identified as follows:
• Channel 1-4 Active Channel/Material: The active material assigned to
a channel appears at the top of the display.
• No Material Selected: If no material matches the channel type, the
channel displays on the Material Library screen as None. A material
can be configured for the channel by selecting an available material at
the Control Setup Screen.
• Disabled: If a channel is disabled from the Channel Setup screen, the
channel displays as Disabled. The channel is turned OFF and is not
configured for operation. To establish a new channel, select the
Channel Setup button.
MATERIAL ASSIGNMENT (MATRL 1-16)
Up to 16 different material names display on the Control Setup screen.
Unassigned materials appear on the Material button with a generic name,
MATRL1. Materials should be given a name that clearly identifies the
material type.
As materials are configured and saved, the Material buttons on the Control
Setup screen changes to the name created at the Material Setup screen.
The Material Setup screen can be accessed at any time by pressing the
Material Name button. Refer to the Material Setup section for further
instructions.