Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 173)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
TROUBLESHOOTING & ALARMS / 165
215 High Pressure Limit
Exceeded Alarm SENSED PRESSURE EXCEEDS THE
HIGH ALARM SETTING ON THE
PRESSURE SETUP SCREEN.
1. Implement malfunction or incorrect
setup.
2. Defective pressure sensor.
3. Defective module.
1. Verify proper implement operation/setup.
2. Inspect pressure sensor for damage.
Replace if necessary.
3. Inspect module for damage. Replace if
necessary.
216 Low Pressure Limit
Exceeded Alarm SENSED PRESSURE BELOW THE LOW
ALARM SETTING ON THE PRESSURE
SETUP SCREEN.
1. Implement malfunction or incorrect setup.
2. Defective pressure sensor.
3. Defective module harness or module.
1. Verify proper implement operation/setup.
2. Inspect pressure sensor for damage.
Replace if necessary.
3. Inspect module and/or module harness for
damage. Replace if necessary.
217 Member module
Detection Alarm NUMBER OF MEMBER MODULES DOES
NOT MATCH THE SYSTEM
CONFIGURATION.
1. Too few modules connect to system.
2. Too many modules connected to
system.
3. Defective CAN/module harness.
4. Blown module harness fuse.
5. Defective module.
6. New module has been added to system.
1. Verify correct module configuration setup
on the Module Configuration screen.
2. Verify correct module configuration setup
on the Module Configuration screen.
3. Identify missing module in the Module
Configuration list. Inspect CAN/module
harness of the missing module for damage.
Repair or replace harness.
4. Inspect module harness fuse of the
identified module. Replace if necessary.
5. Identify missing module in the Module
Configuration list. Inspect missing module
for damage or replace.
6. Verify correct module configuration setup
on the Module Configuration screen.
218 Pressure Sensor
Detection Alarm NUMBER OF PRESSURE SENSORS
CONNECTED DOES NOT AGREE WITH
THE NUMBER OF SENSORS
CONFIGURED ON THE PRESSURE
SENSOR CONFIGURATION SCREEN.
1. Defective Sensor.
2. Defective module or damaged module
harness.
3. Additional pressure sensor detected.
1. Inspect pressure sensor for damage or
replace.
2. Inspect module and/or module harness
for damage. Replace if necessary.
3. Verify correct# ACC setting for each
module.
219 Row Sensor Detection
Alarm NUMBER OF SEED SENSORS
CONNECTED DOES NOT AGREE WITH
THE NUMBER OF SENSORS
CONFIGURED ON THE SEED SENSOR
CONFIGURATION SCREEN.
1. Defective seed sensor.
2. Defective module or damaged module
harness.
3. Additional seed sensor detected.
1. Inspect seed sensor for damage or
replace.
2. Inspect module and/or module harness
for damage. Replace if necessary.
3. Verify correct # ROWS setting for each
module.
ALARM
# ALARM PROBABLE CAUSE CORRECTIVE ACTION