Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 159)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM OPERATION / 151
RESETTING NOVRAM VALUES
(Level 3 User Only)
Level 3 Users only have access to Resetting Novram Values. NOVRAM
refers to the memory location of the Working Set Master (WSMT) module
where all configuration and setup data for the system are stored. Resetting
the NOVRAM will reset all data to factory default constants.
1. From the Main Work screen, press the Diagnostics button.
2. At the Diagnostics screen, press the Memory Reset button to access
the Memory Reset screen.
3. Press the Reset Novram button to reset to factory standard defaults.
4. Press the Diagnostics button to return to the Diagnostics screen.
DO NOT press the NOVRAM Reset button unless you want ALL
system data settings to be reset to factory standard defaults.
It is recommended that NOVRAM not be reset unless instructed by
DICKEY-john Technical Support.
Figure 92
Reset Novram Screen
ACKNOWLEDGING ALARM CONDITIONS
Various alarm conditions may be presented to the operator whenever the
system encounters an abnormal condition or detects a specific alarm.
Alarms are typically in a full screen display describing the alarm and,
dependent upon the alarm type, may give the operator instructions on how
to fix the alarm. Each alarm type has an associated alarm number, which
can be cross-referenced in the TROUBLESHOOTING AND ALARMS
section.