Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 142)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
134 / DATA ITEMS
SEED COUNT ACCUM ROW
Seed Count Accum Row scans through all of the active seed rows and
displays the seed count for each row as detected by the seed sensors. The
value to the left side displays the current row number. The value to the right
is the seed count. The scan continues sequentially in four-second intervals
unless a particular row number is selected for continuous view. The Seed
Count function is enabled/disabled on the Accumulators/Seed Count/
Distance Count screen. This Data Item displays on an entire row of the
Work screen.
DISTANCE ACCUMULATOR
Distance Accumulator displays the distance covered in feet (ft). This
accumulator is independent of any other area accumulator and can be reset
to 0.0 at any time. Current distance is retained after power down.
CHANNELS 1 - 4 MATERIAL ACCUM
Channels 1 - 4 Material Accum displays the current accumulated material
for Channels 1 - 4. Material is accumulated according to the applied rate.
Does not function if channel is planter control.
NOTE: All Data Items are selected
from the Work Configuration
screen. Refer to the Work
Screen Configuration section
for setup instructions.
ACCESSORY INPUT SCAN
PRESSURE SCAN
Pressure Scan scans through all active pressure sensors sequentially,
displaying the actual pressure measured in oz/in
2
(kPa) in four-second
intervals. The current sensor is identified by the number above the pressure
symbol.
1,2,3...
0 10
Reset
0 . 0
FT
Reset
0 . 0
LB
4
Reset
0 . 0 0
OZ
IN
2
1