Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 63)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM CONFIGURATION / 55
CONTROL CHANNEL SETUP
Channel Setup allows configuration of 4 independent control channels.
Control channel choices consist of:
1. Planter Control
2. Granular Fertilizer
3. Granular Seeding
4. Liquid Flow
5. RPM Control
6. Granular Seed Monitor
7. Granular Fertilizer Monitor
8. Split Air Regulation
9. Disabled
A control channel identified as Disabled indicates the channel is not in use.
Control channel parameters that can be configured include:
• Control Mode
• Drive Type
• Drive Frequency
• Input Filter
• Gear Ratio (except Liquid Flow)
• Sensor Constant
• # Seed Rows (Planter Control only)
• Channel Width
• Precharge Time
• Delay Time
• Flush Time
Once a material has been created and linked to a channel type, that
material is automatically assigned to the corresponding channel.
To establish a Control Channel:
1. At the Control Setup screen, press the Channel Setup button to
display the Channel Setup screen.
Refer to the appropriate control channel section for configuring constants.
To configure more than one control channel, press the Next Channel
button.
IMPORTANT: It is recommended that Materials are created before
configuring channels on the Channel Setup screen.