Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 115)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM CONFIGURATION / 107
To Edit # of Hoppers:
1. Enter the number of hoppers assigned for each module.
2. Press the Sensor Detect button to detect and test the hopper sensors.
An hour glass appears in the upper right corner during system
configuration.
3. If the number of sensors detected on each module is not in agreement
with the # of Hopper values entered, an alarm activates.
– Verify that the # of sensors entered on the Hopper Assignment
screen matches the actual number of sensors connected.
– Confirm that all hopper sensor harnessing is connected properly.
Refer to the Troubleshooting section for further information.
HOPPER SET
The Hopper Set screen controls the active state of the hopper sensor as
well as the alarm delay time.
1. Press the Hopper Set button to access the Hopper Set screen.
Figure 66
Hopper Set Screen
LOGIC LEVEL
Logic Level sets the active state of the sensor and allows flexibility to
connect sensors that have different active outputs. There are two settings
available:
NOTE: For a Dj Hopper Level sensor,
this value should be set to
ACTIVE LO.
ACTIVE HIGH
• Sets the active state to “High” signifying that an alarm is generated if
the sensor’s output is in a high state. Use this setting if the connected
sensor outputs a high condition when active.