System modes, Operator’s manual, User level access – Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 User Manual
Page 33: Operate mode
OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM MODES / 25
SYSTEM MODES
The Virtual Terminal has two modes of operation:
• Operate
• Setup/Configuration (Setup constants accessible only with password)
The position of the master switch determines which mode is selected.
USER LEVEL ACCESS
The system has three user levels:
• User Level 1: Operator View
• User Level 2: Setup of constants (system configuration)
• User Level 3: Setup of constants and alarm log reset
The system loads in User Level 1 at every power cycle. Access to User
Level 2 and 3 screens require a password available through Great Plains
Service.
OPERATE MODE
When the Master Switch is in the ON position, the Virtual Terminal (VT) is in
Operate mode. In this mode, all enabled system components and control
channels are operational, as well as all monitoring functions and system
accumulators.
Figure 19
Operate Mode
185