Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 18)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
10 / INSTALLATION
Figure 8
Working Set Master Module
WORKING SET MASTER (WSMT) MODULE
1. Select an area on the implement to mount the WSMT that allows for
easy hookup and access. Use the enclosure as a template to mark the
location of the mounting holes. Drill four 9/32 inch diameter holes
where marked.
IMPORTANT: Do not use the enclosure as a guide when drilling. Do
not overtighten nuts as this may damage the mounting
tabs of the enclosure.
The WSMT may be mounted in any of the following orientations:
Figure 9
Acceptable Orientation
Do not install the module in any orientation other than shown in
(
Figure 9 ). The connection wires must not be mounted upward, as
moisture can collect inside the unit and damage the circuits.
Ensure that module connectors do not face upward when
implement is in a folded position as well.
2. Mount with the label side of module facing out. Do not mount with the
connector facing up (see caution).
6.80”
7.0”
7.45”
3.93”
PREFERRED ACCEPTABLE ACCEPTABLE