Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 141)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
DATA ITEMS / 133
CHANNELS 1 - 4 AREA
Channels 1 - 4 Area displays the area covered by Control Channels 1 - 4.
Area is calculated using the Channel Width parameter that is entered on the
Control Channel setup screen. Area accumulates when the master switch
is ON and the ground speed is above the Shutoff Speed parameter entered
on the Ground Speed Calibration screen. This accumulator is
independent of any other area accumulator and can be reset to 0.0 at any
time. Current area is retained after power down.
AREA SCAN
Area Scan scans through all area accumulators sequentially displaying the
area for each accumulator in four-second intervals.
NOTE: All Data Items are selected
from the Work Configuration
screen. Refer to the Work
Screen Configuration section
for setup instructions.
CONTROL FEEDBACK SCAN
Feedback Scan scans through all active control channel feedback sensors
sequentially displaying the actual RPM or GPM measured in four-second
intervals. The current sensor is identified by the number displayed above
the RPM symbol (planter control, granular seeding, granular fertilizer) or
GPM symbol (liquid flow).
AREA PER HOUR
Area Per Hour displays the current area per hour in acres (Ha). The value is
continuously calculated based on the current ground speed and the
Implement Width parameter as entered on the Row Status/Row Width
Setup screen.
SYSTEM ACTIVE TIME
System Active Time records the amount of time the master switch is in the
ON position indicating the actual number of hours equipment has been
operating.
1 0 . 9 5
AC 1
Reset
0 . 0 0 AC1
0 . 0
CH2
RPM
0 . 0 0
AC
HR
0 . 0 0
HR
Reset