Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 116)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
108 / SYSTEM CONFIGURATION
ACTIVE LO
• Sets the active state to “Low” signifying that an alarm is generated if
the sensor’s output is in a low state. Use this setting if the connected
sensor outputs a low condition when active.
ALARM DELAY
Alarm Delay controls the delay time between the detection of a hopper
alarm condition and the generation of the resulting alarm. The value is
entered in seconds.
CHANNEL
Assigns the hopper sensor to a specific control channel.
ACCESSORY ASSIGNMENT
The Accessory Assignment screen configures optional sensors such as an
RPM to monitor shaft/fan or an air pressure sensor.
The Accessory Assignment screen displays:
• Module address
• Type
• Number of accessories
• Accessory numbers for the system
1. At the Module Configuration screen, press the Accessory
Assignment button to access the Accessory Assignment screen.
Figure 67
Accessory Assignment Screen
IMPORTANT: Auto Config detects the presence of a pressure sensor
and automatically configures and populates into the
Accessory Assignment screen. An RPM sensor must be
configured manually.