Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 104)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
96 / SYSTEM CONFIGURATION
IMPORTANT: If an implement uses more than one module type, mount
the modules on the implement in serial number order
starting on the left side and proceeding to the right.
Auto Sort will then sort the modules in the correct order
for seed sensor assignment. Refer to the Auto Sort
section for instruction.
MODULE ADDRESS
The Module Address column is a critical parameter used to identify
module’s position on the implement and to identify the number of rows
connected to the Working Set Master (WSMT) and Working Set Members
(WSMB) (optional). Accurate placement of the modules is required for
correct console operation.
• Up to 16 seed sensors can connect to the Working Set Master
• Working Set Members can be added to monitor 18 rows each
• Up to 15 Working Set Members can be installed to monitor up to a total
214 rows
The following requirements must be observed when connecting seed
sensors to the WSMT or WSMB:
1. Each Module Address is determined by the order in which the modules
are installed on the implement.
2. The Module Address should always start at the number 1 position.
3. Seed sensors must be connected to the WSMT or WSMB continuously
and consecutively. Any skipped rows will cause an alarm.
Example: Module Address 1 should be assigned to the module connected
to Row 1. Module Address 2 should be assigned to the module connected
to the next set of rows. The assigned numbering continues until all rows
have been numbered.
CLUTCH FOLDING MODULE
The presence of a clutch folding module and planter output module is
detected through the Auto Config button and will appear on the Module
Configuration screen. Refer to CFM Installation Instructions for install and
operating details.