Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 13)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM OVERVIEW / 5
WORKING SET MEMBER (WSMB) MODULE
(OPTIONAL)
Figure 4
Working Set Member Module
Each Working Set Member (WSMB) module is an auxiliary to the Working
Set Master (WSMT). Each WSMB can accept up to 18 rows of seed
sensors. The WSMB passes information directly to the WSMT. Up to 11
WSMB’s can be installed to monitor up to 214 rows. The flexible design of
the WSMB allows for installation virtually anywhere on the implement.
IMPLEMENT LIFT SWITCH (OPTIONAL)
The Implement Lift Switch detects the position of the implement. When
using an Implement Lift Switch, the Master Switch can be left in the ON
position during operation, and the system will be turned OFF and ON as the
implement is raised and lowered. The Master Switch should be turned OFF
when in transport, when stationary, or when the operator has left the cab.
CAN TERMINATORS
CAN Terminators are necessary for proper communication between each
component of the system.
• One terminator is located on the cab harness, approximately 30 inches
from the Virtual Terminal connector.
• One terminator plugs into the implement harness of the last module
connected to the CAN bus.
Figure 5
Can Terminator
4.63
4.00
5.24
.291
2 holes
4.68 1.37
2.36
0.630