Unitec POS4000/V2 - Manual (Page 89)

POS4000
Document Number: POS4003 81
Document Title: POS4000/V2 Operations Manual
the secondary menu that follows:
Change Wash Name
Set Reg. Postscript
Set Dis 1 Postscript
Set Dis 1 Postscript
Set Postscript All $
To execute one of the secondary commands, scroll through the secondary menu
until the command of interest is displayed, and then press the [ENTER] key.
6.13.1 Change Feature Name
To change the name (or label) of a feature, scroll through the Setup secondary
menu until "Change Wash Name" is displayed. Then press the [ENTER] key.
At this point, the top line of the display will prompt you to Enter Label Name and
the second line will display the current name of the feature. By using the
alphanumeric characters on the keys (see appendix II), you should type in the
new name of the feature.
If you press [ENTER] when the current name is displayed,
WARNING!!
you will change the label to be BLANK.
The [BOLD], [CENTER] and [RED] keys have no effect on
wash names.
Note: