Unitec POS4000/V2 - Manual (Page 77)

POS4000
Document Number: POS4003 69
Document Title: POS4000/V2 Operations Manual
Line #, 99 All. Individual message lines can be changed (enter the line number
to change) or the entire message can be changed (enter 99). Type the line
number to change (i.e.. 1, 2, 3...) or 99 to change the entire message, followed
by the [ENTER] key.
Next, you will be prompted to enter the message for each line using the alternate
key functions shown on the right side of the keys (see APPENDIX II).
When the "change entire message" option is selected, the console will prompt for
the text for the first line first. You should type in the text you want for line 1
followed by the [ENTER] key. Next, the console will prompt for the next line and
so on until all lines are completed. All lines must be entered even if they are to
be blank.
When you want a line to be blank, press only the [ENTER] key when the console
prompts for the text for that line. Blank lines will be printed only if non-blank lines
follow them. For example, if the last two lines of a message are blank they will
not generate blank lines when printed.
To simplify the message setup, it is recommended that the
"change entire message" function be selected when several lines o
Note:
f
a message are being changed. This will minimize the number of
times the command has to be executed.
Example to change header message text:
[CMD]
[SET MESSAGES]
[1]
(password 1)
[ENTER]
(Example to change header message text cont.)
[MENU UP/DOWN] until "Change Header Msg." appears
[ENTER]
[9][9]
(to change all lines of message)
[ENTER]
[T][H][I][S][ ][I][S][ ][A][ ][T][E][S][T]
[ENTER]
* (repeat for each line)
*
[ENTER]