Unitec POS4000/V2 - Manual (Page 57)

POS4000
Document Number: POS4003 49
Document Title: POS4000/V2 Operations Manual
Example to set the POS MAX WASHES to 3 (max of 3 washes allowed):
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "External POS MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Set POS MAX WASHES" appears
[ENTER]
[3][ENTER]
to select maximum of 3 wash types to be given
The current EXT POS settings will print out with a mapping of
the carwash t
Note:
ype given vs. the carwash type requested.
6 . 2 . 1 0 . 4 S e t S e n d C o d e A g e
This command is used to enable the POS1 or POS2 protocol to include the
response code for code age and wash status. In some cases when this feature is
not enabled (default) the receipt printed out at the gas pump will show that the
code is valid for 1 day only. Enabling this value may cause the system to not
work properly with some point of sale manufacturers. As of 3/9/98 Gilbarco
systems will function with this feature enabled, Dresser Wayne systems will not.
To select this command, scroll through the External POS sub-menu until “Set
Send Code Age” appears and then press the indicated function key.
Example to set send code age enabled:
[CMD] to select command mode
[2-System Setup] to select "System Setup" menu
[3] Enter your password 3
[ENTER]
[Menu up] Until you see: "Ext. POS MENU->"
[Menu up] Until you see “Set Send Code Age”
[Enter] Select function
[ 1 ] To enable set send code age
[ENTER]