Unitec POS4000/V2 - Manual (Page 81)

POS4000
Document Number: POS4003 73
Document Title: POS4000/V2 Operations Manual
[ENTER]
[MENU UP/DOWN] until "Print Message Config" appears
[ENTER]
6.8 Set Passwords
This command allows you to change the passwords that control access to
specific commands. To select this command press the [CMD] key followed
by the [PASSWORDS] key. You will be prompted to enter password 3.
Once the correct password is entered, you can scroll through the
secondary menu that follows:
Change Password 1
Change Password 2
Change Password 3
Change Password 5
Change Serial Pass (password used for access via serial port)
To execute one of the secondary commands, scroll through the secondary menu
until the command of interest is displayed, and then press the [ENTER] key.
6.8.1 Change a Specific Password
To change a password, scroll through the secondary menu until the password of
interest is displayed, and press the [ENTER] key. At that point, you will be
prompted to enter a new password. Enter a numeric password between 0 and
4,294,967,295 and then press the [ENTER] key. The new password will be
printed as a confirmation. Save and protect access to this password.
Example to change password 1 to 12345:
[CMD]
[PASS WORDS]
[3]
(Password 3)
[ENTER]
Password 4 cannot be changed. It is intended to be used b
Note:
y
service personnel. Password 4 only allows access to the Service
Routines command.