Unitec POS4000/V2 - Manual (Page 76)

POS4000
Document Number: POS4003 68
Document Title: POS4000/V2 Operations Manual
[CLEAR REPORTS]
[MENU UP/DOWN] until "Clear Manager Counts" appears
[ENTER]
[2]
(password 2, depends on level requested)
[ENTER]
6.7 Set Messages
This command allows you to define the Header Message that is printed at the top
of each ticket, the footer message that is printed at the bottom of each ticket and
the Postscript messages that are optionally printed at the bottom of tickets.
To select the Set Messages command, press the [CMD] key followed by the
[SET MSGS] key. The console will prompt you to enter password 1. Once the
correct password in entered, you can scroll through the secondary menu that
follows:
Change Header Msg.
Change Postscript 1
Change Postscript 2
Change Postscript 3
Change Postscript 4
Change Postscript 5
Change Footer Msg.
Change Coinbox Msg. (Esystem 4000 only)
Print Message Config
To execute one of the secondary commands, scroll through the secondary menu
until the command of interest is displayed, and then press the [ENTER] key.
6.7.1 Change Header Message
The Header Message is printed at the top of every ticket. It can be up to 10 lines
long with each line containing up to 40 regular sized black or red characters (20 if
bold characters are used). To change the Header message, scroll through the
Set Messages secondary menu until "Change Header Msg" appears, then press
the [ENTER] key.
Once the secondary menu item is selected, the console will prompt you to Enter