Unitec POS4000/V2 - Manual (Page 74)

POS4000
Document Number: POS4003 66
Document Title: POS4000/V2 Operations Manual
The following procedure tests each LED:
[CMD]
[SERVICE]
[6][2][7][4][7] Password 4
[ENTER]
[MENU UP/DOWN]
until "LED Test" appears
[ENTER]
[MENU UP]
[ENTER]
Wash-In-Use LED should turn on
[MENU UP]
[ENTER] Wash-In-Use LED should turn Off, Out-Of-Service LED
should turn on
[MENU UP]
[ENTER] Out-Of-Service LED should turn off, LED 3 should turn on
[MENU UP]
[ENTER] LED 3 should turn off, LED 4 should turn on
[MENU UP]
[ENTER] LED 4 should turn off and the commanded is terminated
6.5.4 Set Print To display (Non printer Mode)
This command implemented in Version 6.67 allows the manual control of printing
the customer’s code to the display during a code printing. It is intended for when
the ticket printer connected to the POS4000 is not functioning properly. When
Set print to display is enabled, the customer code will be displayed on the
POS4000 main screen for 10 seconds then cleared. The cashier must write this
code down before it clears. While the code is displayed, no other code can be
generated. The cashier must wait for the first customer code to clear before
proceeding.