Unitec POS4000/V2 - Manual (Page 59)

POS4000
Document Number: POS4003 51
Document Title: POS4000/V2 Operations Manual
If you use groups, you must also set the POS OFFSET (Se Section 6.2.10.1).
This function only works with POS 1 & POS 2.
Example to set Reverse order to Enabled:
[CMD] to select command mode
[2-System Setup] to select "System Setup" menu
[3] Enter your password 3
[ENTER]
[Menu up] Until you see: "Ext. POS MENU->"
[Menu up] Until you see “Reverse order”
[Enter] Select function
[ 1 ][Enter] To enable select 1
6 . 2 . 1 0 . 6 S e t D e f a u l t D i s c o u n t L e v e l s
Setting the default discount levels of the EXTPOS washes will make it so that
when the EXTPOS wash is requesting a code, the accounting will assign a
specific discount level to the purchase. This will happen even though the EXT
POS device does not tell the POS4000 the discount level at which the wash was
sold. This feature can only be accomplished C-store register systems that can
do the following:
This feature is for use with POS 1, 2 and 3.
Note:
(Software ver. 7.4)
•
Allow washes to be sold at pump or register only
•
Allow the configuration of 6 or more discrete wash types
(depending on the discount levels you need to implement the register
may have to accommodate up to 12 wash types)
Whenever this function is accessed, a report will print out to show the mapping of
the washes.
Refer to Appendix XIV for an application note on this feature.