Unitec POS4000/V2 - Manual (Page 45)

POS4000
Document Number: POS4003 37
Document Title: POS4000/V2 Operations Manual
(Example Group 3 to Program 1 Cont.)
[Prog 1] (select wash functions in group)
[Opt 1]
[Opt 2]
[Opt 4]
[ENTER]
6.2.3 Set Code Age Warning
This command allows you to change the code age warning message printed on customer
tickets. Unitec recommends that this be left at the factory default setting of ‘0’ which will cause
no code age warning to be printed on the ticket. The code age value may also be used by the
Convenience Store POS System and Pump for printing code age warnings on customer
receipts. Because the code age warning printed at the store POS and pump is controlled by the
store POS system, Customers should contact their POS supplier or distributor for guidance in
configuring the POS system for this message.
Should the Operator choose to provide a code age warning message on receipts, the procedure
is as follows:
Scroll through the configuration secondary menu until "Set Code Age Warning" is displayed and
press the [ENTER] key.
Once selected, you will be prompted to Enter # of Days Good. The default value should be 0 (no
message will be printed on customer tickets). Enter the value for number of days to use in the
code age warning message. If 1 is entered, the message will be "Code is Good One Time
Today
Only". If a number between 1 and 30 is entered, the message will be "Good Once During Next #
Days".
Note that with a multiple-console configuration, when code age is changed on the master
console, it is immediately downloaded to the remote consoles.
Carwash codes are NOT automatically removed from memory when this time
expires and they will still be usable. If you wish to enforce the code age warning, you
must use the Memory Information/Clear Old Codes command.
Important: