Unitec POS4000/V2 - Manual (Page 87)

POS4000
Document Number: POS4003 79
Document Title: POS4000/V2 Operations Manual
[272001] (Lockout password )
[ENTER]
Screen should show “Lock Console Sales”
[ENTER]
[1]
1 to Enable (0 to disable)
[ENTER]
6.11.2 Change Lockout Password
This function is used to change the Console Code Lockout password.
Example to Change Lockout Password:
[Menu Down] until you see “Code Sales Lockout”
[Enter]
[272001]
(Default Lockout password )
[ENTER]
Screen should show “Lock Console Sales”
[Menu Up]
Screen should show “Change Password”
[ENTER]
[XXXXX]
Enter new password (up to 8 digits)
[ENTER]
6.12 Check Code Status
This command allows you to check the status of a code. To access this
command, press the [CMD] key followed by the [CHECK CODE] key. The
console will prompt you to enter the code to check. Type the code to check
followed by the [ENTER] key. The console will print the status of the code as
either valid, used, previously canceled or not in memory.
If the code is valid, the date/time it was issued and the features associated with
are printed. If the code has been used, the date/time it was redeemed is printed.
If the code was previously canceled (using the void code command), the
date/time that it was canceled is printed. If the code is not found in memory, the
date and time of the oldest valid and used codes currently held in memory will be
printed.