Unitec POS4000/V2 - Manual (Page 62)

POS4000
Document Number: POS4003 54
Document Title: POS4000/V2 Operations Manual
[ENTER]
[MENU UP/DOWN] until "Set Unit Number" appears
[ENTER]
[3]
[ENTER]
6 . 2 . 1 1 . 2 C o n t r o l l e r / R e m o t e
This command is used to designate a POS4000 main console as either a
controller console or a remote console. Refer to APPENDIX VII for additional
information.
To select this command, scroll through the Multiple Unit sub-menu until
"Controller/Remote" appears and then press [ENTER].
Example to designate a main console as a REMOTE Console:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "Multiple Unit MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Controller/Remote" appears
[ENTER]
[2]
to select Remote
[ENTER]
The default unit number is 1.
Note:
The default is for the console unit to be a controller.
Note: