Unitec POS4000/V2 - Manual (Page 86)

POS4000
Document Number: POS4003 78
Document Title: POS4000/V2 Operations Manual
6.11 Code Sales Lockout
This menu of commands allows the POS4000 to lock out code sales at the
console. This is available if you want to disable the ability to sell codes from the
console only. This can be used for instance when the POS4000 is connected to
an External POS device (Site controller or Register) and it is desired to keep from
issuing sales from the console. Two functions are available:
Lock Console Sales – Enables or Disables console sales
Change Password – Changes the Code lockout password
6.11.1 Lock Console Sales
This function is used to enable or disable the Console code sales. When
enabled, no codes can be printed from the console. No external POS functions
will be affected by this feature. Check a code and Void a code functions are also
not affected by this feature.
Example to enable console code sales lockout feature:
[Menu Down] until you see “Code Sales Lockout”
[Enter]
Codes deleted will NOT be found using the check code
command.
Note:
Depending upon the number of codes being deleted, this
command may require several minutes to complete. This is
normal. During this time, other functions can not be performed
at the console, but the processing of codes entered at the car
wash is not affected.
Note:
This menu is password protected by the “Code Lockout
Password”. This password is defaulted to 272001.
Note: