Unitec POS4000/V2 - Manual (Page 142)

POS4000
Document Number: POS4003 134
Document Title: POS4000/V2 Operations Manual
15) Power up all coin boxes
16) Power up all remote consoles and connect Communications cable
17) Power up controller (master) console and connect communications cable.
18) Configure the Prices, wash names, code length etc on controller console if
not done so already.
19) Configure the messages for the remote console if you have one.
20) Configure each console linked to an EXT POS.
21) If you are using remote consoles, perform a “Program remote Consoles”
command; this will assure the downloading of important information to any
remote console. (See section 6.2.11.4)
22) Verify that you can print codes from the remote console and that the ticket
Header and footer messages are correct. Also verify prices on ticket are
correct.
23) Verify codes are accepted at all carwash bays.
Refer to enclosed drawings for connecting multi-units configurations.