Festo Электромотор MTR-DCI - Manual (Page 97)

4. The control panel (type MTR-DCI-...-H2 only)
4-23
Festo P.BE-MTR-DCI-DN-EN en 1209a
5. Confirm the digit with OK .
6. Set the digit for the next input position “?”.
7. After entering the third digit, save your setting with SAVE
.
4.5.6 [Settings] [BUS parameter]
Setting Fieldbus parameters.
[BUS parameter] Param. Description
[MAC ID] 0 ... 63
(0 ...3fh) Fieldbus address of the MTR-DCI.
Representation:
“0 dec, 0 hex”...“63 dec, 3f hex”
[Bit rate] 500 kbit/s,
250 kbit/s,
125 kbit/s Fieldbus bit rate corresponding to the settings on the master.
[I/O DATA] 8 bytes
16 bytes I/O data length setting
– 8 bytes: only for the FHPP standard (control of the MTR-DCI
is done as per the Festo Handling and Positioning Profile)
– 16 bytes: FHPP standard and FPC (additional use of the
Festo Parameter Channel for parameterising the MTR-DCI)
Tab. 4/10: [Settings] [BUS Parameter] menu
<- -> Select the parameter setting using the arrow
buttons.
OK Confirm the selection using the button.
ESC Pressing the
The settings made in the [BUS Parameter] menu are saved
directly and permanently (including in the event of a power
failure) to the EEPROM when you confirm them with
OK.