Festo Электромотор MTR-DCI - Manual (Page 80)

4. The control panel (type MTR-DCI-...-H2 only)
4-6
Festo P.BE-MTR-DCI-DN-EN en 1209a
4.2 The menu system
4.2.1 Accessing the main menu
When the power supply is switched on, the MTR-DCI auto-
matically carries out an internal check. At first the display
briefly shows the Festo logo, then changes to the status dis-
play. The status display shows the following information:
– The type designation of your MTR-DCI
– The current position of the drive x a = ....
– The current setting for device control
(HMI = Human Machine Interface)
The current button function is indicated in the lines at the
bottom of the display:
The main menu is accessed from the status dis-
play using the
4.2.2 Selecting a menu command
<- -> You can use the arrow buttons on the control
panel to select a menu item from the list. The
current selection is marked with an arrow
(
} Diagnostic). Select S to display further
menu commands.
ESC You can use the
OK The button is used to confirm the current
selection or entry.
MTR-DCI...
X
a
= 0.00 mm
HMI:off
} Diagnostic
Positioning
Settings
*
S
ESC
<-->
OK
} HMI control
LCD adjustment
s ESC
<-->
OK