Festo Электромотор MTR-DCI - Manual (Page 198)

6. Diagnosis and error display
6-8
Festo P.BE-MTR-DCI-DN-EN en 1209a
Cate-
gory Status
bytes
2)
Fault
LED Fault
number Device
Error
1)
Description Name, display
Warning HOT TEMPERATURE Temperature too
high – – FLASHING WARN
Warning COLD TEMPERA-
TURE Temperature too
low – – FLASHING WARN
1) See PNU 205 / CI 2FF1/00
2) For FHPP status bytes, see section 5.5.2
Tab. 6/6: Faults and warnings with fault numbers and fault bits
6.3.2 Description of the messages, warnings, and faults
Messages Messages give information regarding operating states
Notification Cause
Attention!
Motor moves... Message before the start of a positioning move-
ment. After confirmation with the button,
the drive starts moving.
Profile velocity
= 0. Please set
v. The menu command [Move position set] is not
being executed because the positioning speed of
the position set record is v = 0. Modify the
parameter assignment or select a different
position set record.