Horner APG SmartStack I/O HE800PBS600/HEPBS600 - Manual (Page 69)

CH9: Diagnostics
MAN0575-04-EN
PAGE 69 of 97
© Horner APG.This drawing is the property of Horner APG. And shall not be disclosed or reproduced except as specifically authorised.
Profibus Modules User Manual
EO 09-0009
The following table lists the typical steps to use the I/O Watch monitor.
Preconditions:
The project/configuration already exists, containing a PROFIBUS-DP Master and the PROFIBUS-DP
Slave(s) as described in section Getting Started – CscaPe Configuration..
The Configuration has been downloaded to the PROFIBUS-DP Master using Online > Download
Running bus system.
Open the existing project using File > Open. Open the Windows dropdown menu and select Window
> Logical Network View to change the window. A window with three sections opens:
Left Window Centre Window Right Window
Project Tree structure Tag / Symbol IO Watch
Open the tree structure in the left window to reach the I/O module of the desired device:
Project > Master > Slave > Modul > (possible) Submodul
.
Left click on the module desired and the tags (I/Os) will be displayed in the centre window of the
Logical Network View.
Select with the left mouse button the tag/symbol desired and drag and drop them in the right window
of the Logical Network View.
In the right window, select the desired tag with the left mouse click to highlight it then right mouse click
to open a menu. Select Start. A new window called IO Watch appears.
A table shows the Device, Symbolic Name, IEC Address (Offset), Data type Representation and
Value. Select the line with the desired information. Click on Hex under Representation and select the
way the values are to be displayed. Choices are Hex, Decimal unsigned, decimal signed, Bit pattern.
Input data is displayed and can’t be changed. Output data may be entered into the value