Horner APG SmartStack I/O HE800PBS600/HEPBS600 User Manual
Page 16
Getting Started
MAN0575-04-EN
PAGE 16 of 97
© Horner APG.This drawing is the property of Horner APG. And shall not be disclosed or reproduced except as specifically authorised.
Profibus Modules User Manual
EO 09-0009
3.4
Configuration of a SmartStack Profibus DP Slave to any Profibus DP Master
The following table describes the steps to configure a SmartStack DP Slave to any DP Master:
Action
Menu in the System Configurator
•
Create a new project
File > New > PROFIBUS
•
Choose Horner DP Master and provide bus address (*1) Insert > Master
•
Choose Horner DP Slave and provide bus address
Insert > Slave
•
Assign the input and output modules (*2)
Mark the Slave (left Mouse click), then
Settings > Slave Configuration
•
Set device assignment if no automatic assignment has
occurred
Mark the Slave (left Mouse click), then
Settings > Device Assignment
•
Save project
File > Save
•
Download
Mark the Slave (left Mouse click), then
Online > Download
•
Configuration diagnostic
Mark the Slave (left Mouse click), then
Online > Extended Device Diagnostic >
SPC3CTRL Slave Config
•
Configuration diagnostic
Mark the Slave (left Mouse click), then
Online > Extended Device Diagnostic >
SPC3CTRL Master Config
•
Transfer user data:
Write output, read input
Mark the Slave (left Mouse click), then
Online > I/O Monitor
Figure 3.3. Steps for Configuration of a SmartStack Profibus DP Slave to any Profibus DP
Master
Note (*1): Insert a SmartStack DP Master. This Master is a placeholder and it is not necessary to
match the connected Master.
Note (*2): The Offset addresses assigned in the Slave configuration are always related to the DP
Master.