Horner APG SmartStack I/O HE800PBS600/HEPBS600 - Manual (Page 46)

DP Slave
MAN0575-04-EN
PAGE 46 of 97
© Horner APG.This drawing is the property of Horner APG. And shall not be disclosed or reproduced except as specifically authorised.
Profibus Modules User Manual
EO 09-0009
The global Auto Clear function is carried out or ignored when the connection to the Slave is
interrupted.
DPV1
Maximum Channel Data Length
Defines the maximum length of the DPV1 telegrams. The Slave will adapt its buffer size for the
respective data count.
Diagnostic Update Delay
Some newer Slave devices require more time for the consistency testing for the processing of the
SET_PRM parameterising telegrams. Often, therefore, a simple diagnostic cycle is insufficient
time for the participant to inform the Master of the release for the DATA_EXCHANGE. With the
diagnostic delay, the number of diagnostic cycles that is the maximum that the Master expects in
order to obtain this release is increased before it reports an error.
Maximum Alarm PDU Length
Determines the maximum length of the DPV1 Alarm telegrams.
Maximum Active Alarms
Determines the maximum quantity of active alarms: one alarm of each type or 2, 4, 8, 12, 16, 24
or 32 alarms in total.
Slave Functions
Extra Service Access Point for Alarm acknowledgement
Determine whether the DPV1 Master receipts an alarm to the DPV1 Slave via SAP 51 or 50.
Configuration Data convention
Determines whether the configuration data are interpreted according to EN 50170 or DPV1.
Enabled Alarms
Activates or deactivates the alarms (Module pulled), Process Alarm, Diagnostic Alarm, Manufacturer
Alarm, Status Alarm and Update Alarm.
7.4 Project
Information
If the user creates a project, the project information can be typed in the Settings > Project
Information menu. The information may be viewed at any time by opening the window again.
Figure 25: Settings > Project Information