HP StorageWorks 2.140 Director Switch - Manual (Page 98)

Configuring the director 98
On the tool bar the Display By option and the Search Box option are disabled.
Accessing SANtegrity Authentication tabs
There are five tabs in the Authentication section:
• Users—Allows the security administrator to set up users accessing the switch from CLI and web
interfaces to the switch or director. With the User tab, the Security Administrator specifies
whether the Telnet and HAFM Basic interfaces are enabled, what method the switch or director
uses to authenticate users, and which users are authorized to use these interfaces.
• Software—Allows the security administrator to set up software applications that can
communicate with the switch through API. The most common use of this tab is to define the
security settings for this server, so the switch or director can authenticate server requests to
manage the switch or director. This tab is also used to configure security setting for OSMS
(in-band) management.
• Device—Allows the security administrator to set device-to-device authentication parameters. The
Device tab is PFE key-enabled. If a proper PFE key is not provided, the Device tab is not
accessible.
• IP Access Control List—Allows the security administrator to set up IP addresses that can manage
the switch.
• Radius Server—Allows the security administrator to set Radius server parameters that the switch
can use to pass on the authentication information to the designated Radius servers.
Common features about tabs
Only managed products that support SANTegrity Authentication can be configured. Non-managed
products display with generic icons in the Authentication Product Configuration table. The tab area
is displayed as gray for both non-managed products and managed products at the wrong firmware
level.
Common buttons displayed on tabs
• Use Reset to discard any changes you have entered on the tab and reload the settings from the
switch or director.
• Use Apply to apply changes made on this tab to the switch or director.
• Use Apply To to apply changes made on this tab to this switch or director, as well as to other
switches or directors in this fabric. When you click Apply To, the Apply To Other Products dialog
box is displayed, so you can select the other switches and directors to which to apply the
changes.
NOTE: Apply To is not available on the Element Manager SANtegrity Authentication tabs. Apply
To is available on the HAFM application SANtegrity Security Center tabs, except for the Devices
tab.
• Use the Apply To Other Products dialog box to select the switches or directors to which you want
to send the changes.