HP StorageWorks 2.140 Director Switch - Manual (Page 107)

Director Element Manager user guide 107
Enabling OSMS authentication
OSMS is a PFE key-dependent feature. If the license key is not installed, then OSMS authentication
is not available.
Applying changes and confirmation
To apply the change:
1. From the Software tab, click OK on the Apply or Apply To dialog box.
The Security Change Confirmation and Status dialog box is displayed. This dialog box is similar
to the dialog box that is displayed from the Users tab. The only difference is the Detailed
Change table. This table displays the difference between the current settings of the Software tab
and the to-be-populated new settings. The behavior of this dialog box is the same as the dialog
box for the Users tab.
2. Click Start.
If there are no security settings being changed and you click Apply or Apply To, the To Security
Change Confirmation and Status dialog box is displayed with a message indicating no changes
were found. Click Start and a message is displayed in the Status window indicating the security
settings are identical and that there are no changes to apply.
Using the Devices tab
The Devices tab ( Figure 39 ) defines what switches and directors are eligible to mutually authenticate
with the highlighted switch on the top table. The features in the Devices tab can be configured only
if the switch has the proper PFE key installed. If not, when you click the Devices tab, a message is
displayed indicating the feature has not been installed.
Figure 39 Configure Security Authentication Devices tab
To have two connected switches authenticate each other locally, each switch must have its own user
ID, Node WWN, and CHAP secret, as well as the other switch’s user ID and CHAP secret. The