Figure 51 address configuration library dialog box, 51 address configuration library dialog box – HP StorageWorks 2.140 Director Switch User Manual
Page 130
Configuring the director
130
on page 129, port address 07 is prohibited from communicating with port address
05. Also, Port OC is prohibited from communicating with all other port addresses.
4.
Click Save As to open the Save Address Configuration As dialog box.
5.
Click the Port Name field and enter a name.
Names must be between 1 and 8 characters in length. Valid characters are uppercase A–Z,
0–9, hyphen (-), and underscore (_). The name may not be CON, AUX, COMn (n=1-9), LPTn
(n=1-9), NUL, or PRN.
Descriptions must be between 0 and 24 characters in length. Up to 24 alphanumeric characters
are allowed, including spaces, hyphens, and underscores.
6.
Click OK to save changes and to close the Save Address Configuration As dialog box.
7.
In the Configure Addresses–“Active” dialog box, click Activate to activate the configuration or
click Cancel to close without activating.
NOTE:
If you click Cancel after saving, your configuration will still be added to the library
without being activated.
Managing stored address configurations (FICON Management Style)
This procedure applies only to a director that is using FICON Management Style.
Once address configurations are created through the Configure Addresses–“Active” dialog box,
they are saved to the Address Configuration Library. Use this procedure to manage address
configurations in the Address Configuration Library.
To manage saved library entries:
1.
Select Configure > Addresses on the menu bar and then click Stored.
The Address Configuration Library dialog box is displayed, as shown in
Figure 51
Address Configuration Library dialog box
2.
Select a configuration entry by selecting a row. Then use one of the procedures below.
• Click Modify to modify a stored configuration. The Configure Addresses dialog box is
displayed for the configuration. See ”
Configuring port addresses (FICON Management
” on page 128 for details on using this dialog box.
• Click Delete to delete a stored configuration. A warning is displayed before deletion.