beautypg.com

Enabling and disabling switch binding, Figure 88 switch binding state change dialog box, Editing the switch membership list – HP StorageWorks 2.140 Director Switch User Manual

Page 189: 88 switch binding state change dialog box

background image

Director Element Manager user guide 189

Enabling and disabling Switch Binding

To enable switch binding:

1.

Select Configure > Switch Binding > Change State.

The Switch Binding State Change dialog box is displayed, as shown in

Figure 88

.

Figure 88

Switch Binding State Change dialog box

2.

Perform one of the following steps:
• To disable switch binding, click Enable Switch Binding to clear the Enable Switch

Binding check box, then click Activate.

• To enable switch binding, click Enable Switch Binding to add a check mark, then go to

step 3

to set the Connection Policy.

3.

Click one of the Connection Policy option buttons.
Restrict E_Ports—Select this option if you want to restrict connections from specific switches to

switch E_Ports. Switch WWNs can be added to the Switch Membership List to allow

connection and removed from the Membership List to prohibit connection. Devices are

allowed to connect to any F_Port.

Restrict F_Ports—Select this option if you want to restrict connections from specific devices to

switch F_Ports. Device WWNs can be added to the Switch Membership List to allow

connection and removed from the Membership List to prohibit connection. Switches are

allowed to connect to any E_Port.

Restrict All—Select this option if you want to restrict connections from specific devices to

switch F_Ports and switches to switch E_Ports. Device and switch WWNs can be added to

the Switch Membership List to allow connection and removed from the Membership List to

prohibit connection.

4.

Click Activate.

5.

Edit the Switch Membership List through the Switch Binding Membership List dialog box to add

or remove switches and devices that are allowed to connect with the switch.

Editing the switch membership list

To edit the switch membership list:

1.

Select Configure > Switch Binding > Edit Membership List.

The Switch Binding Membership List dialog box is displayed, as shown in

Figure 89

.

This manual is related to the following products: