HP StorageWorks 2.140 Director Switch - Manual (Page 201)

Director Element Manager user guide 201
Are you sure you want
to overwrite this zone
set?
The selected zone set will be
overwritten in the zoning library.
Click Yes to overwrite or No to cancel.
Are you sure you want
to remove all members
from this zone?
All members will be deleted from
the selected zone.
Click Yes to delete the members or No
to cancel the operation.
Cannot add a switch to
a zone.
The device that you are
attempting to add to the zone is a
switch, which cannot be added to
a zone.
Specify the port number or
corresponding WWN for the device
you want to add to the zone.
Cannot connect to
management server.
The HAFM application at a
remote workstation could not
connect to the HAFM appliance.
Verify that the HAFM appliance
internet protocol (IP) address is valid.
Cannot delete product.
The selected product cannot be
deleted.
Verify the HAFM appliance-to-product
link is up.
If the link is up:
The HAFM appliance may be busy.
Another Element Manager instance
may be open.
You may not have permission to delete
the product.
Cannot disable Fabric
Binding while
Enterprise Fabric Mode
is active.
You attempted to disable Fabric
Binding through the Fabric
Binding dialog box, but
Enterprise Fabric Mode was
enabled.
Disable Enterprise Fabric Mode
through the Enterprise Fabric Mode
dialog box in the HAFM application
before disabling Fabric Binding.
Cannot display route.
All switches in route
must be managed by the
same server.
You cannot show the route
between devices that are attached
to switches or directors managed
by a different HAFM appliance.
Make sure devices named in the Show
Routes dialog box are attached to
products managed by this HAFM
appliance.
Cannot display route.
All switches in route
must support routing.
You cannot show the route
through a fabric that has switches
or directors that do not support
routing.
The route must contain only Edge
Switch 2/16s, Edge Switch 2/32s,
Director 2/64s, or Director 2/140s.
Table 11 HAFM messages (continued)
Message Description Action