HP StorageWorks 2.140 Director Switch - Manual (Page 144)

Configuring the director 144
12. Click Finish.
The Configure Threshold Alerts dialog box is displayed listing the name, type, and state of the
alert that you just configured.
13. At this point, the alert is not active. To activate the alert, select the alert information that is
displayed in the Configure Threshold Alerts table and click Activate.
The alert is activated, as shown in Figure 65 .
Figure 65 Configure Threshold Alerts dialog box–alert activated
Modifying alerts
To modify an existing threshold alert:
1. At the Hardware view page, select Configure > Threshold Alerts.
The Configure Threshold Alerts dialog box is displayed.
2. Select the alert that you want to modify when you click the alert information in the table.
(If the alert is active, an error message is displayed prompting you to deactivate the alert.)
3. If the alert is active, click Deactivate, then select the alert information in the table again.
4. Click Modify.
An initial Modify Threshold screen is displayed where you can change the threshold type.
5. Select a threshold type from the list.
6. Click Next when you are done.
A Modify Threshold screen is displayed. You can use this screen to change the % utilization,
cumulative minutes for the threshold to occur before notification, and the time interval for
measuring throughput and for alert notification.
7. Make appropriate changes.
Then, continue through the Modify Threshold screens, making changes as necessary, until the
summary screen displays the alert configuration.
8. If you need to change any parameters, click Previous or Next to display the desired Modify
Threshold screen.
9. Click Finish when you are done.