HP StorageWorks 2.140 Director Switch - Manual (Page 217)

Director Element Manager user guide 217
Are you sure you want
to delete firmware
version?
Confirmation to delete a firmware
version. The firmware library can
store up to 8 firmware versions.
Click Yes to delete the firmware version
or No to abort the operation.
Are you sure you want
to delete this address
configuration?
Confirmation to delete the selected
address configuration.
Click Yes to confirm the deletion of the
address configuration or No to cancel
the operation.
Are you sure you want
to send firmware
version?
Confirmation to send a firmware
version from the HAFM
appliance’s firmware library to the
director. Firmware library can
store up to 8 firmware versions.
Click Yes to send the firmware version
or No to abort the operation.
Cannot change Port
Type while Management
Style is FICON without
SANtegrity feature.
Please contact your
sales representative.
Firmware is below the required
level and you attempted to change
a port type in the Configure Ports
dialog box while FICON
Management Style, but the
optional SANtegrity Binding
feature is not installed.
Informational message. If the firmware
is below the required level, install
SANtegrity Binding before changing
port types in the Configure Ports
dialog box while in FICON
Management Style.
Cannot create
partition
while FICON Management
Server is enabled.
The user has moved slots into a
partition while FMS Server is
enabled.
Disable the FMS Server before
moving slots into a partition.
Cannot disable Switch
Binding while
Enterprise Fabric Mode
is active and the
switch is Online.
You attempted to disable Switch
Binding through the Switch
Binding Change State dialog
box, but Enterprise Fabric Mode is
enabled.
You must either disable Enterprise
Fabric Mode using the Enterprise
Fabric Mode dialog box in the HAFM
application or set the switch off line
before you can disable Switch Binding.
Cannot disable
Insistent Domain ID
while Fabric Binding
is active.
You attempted to disable the
Insistent Domain ID parameter
through the Configure Switch
Parameters dialog box, but Fabric
Binding is enabled.
Disable Fabric Binding through the
Fabric Binding dialog box before
disabling these parameters.
Cannot enable
beaconing on a failed
FRU.
Occurs when selecting Enable
Beaconing option for a failed FRU.
Replace the FRU and enable
beaconing again or enable beaconing
on operating FRU.
Table 12 Element Manager messages (continued)
Message Description Action