HP StorageWorks 2.140 Director Switch - Manual (Page 220)

Information and error messages 220
Cannot retrieve switch
state.
The director or switch state cannot
be retrieved by the Element
Manager because the Ethernet
link is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot run diagnostics
on a port that is
failed.
Port diagnostics (loopback tests)
cannot be performed on a port
that has failed any previous
diagnostic (power-on diagnostic,
on line diagnostic, or loopback
test). The amber LED associated
with the port is illuminated to
indicate the failed state.
Reset the port and perform diagnostics
again.
Cannot run diagnostics
on an active E_port.
Port diagnostics cannot be
performed on an active E_port.
Run diagnostics on an E_port only
when it is not active.
Cannot run diagnostics
on a port that is not
installed.
Port diagnostics cannot be
performed on a port card that is
not installed.
Run diagnostics only on a port that is
installed.
Cannot run diagnostics
on a port card that is
not installed.
Port diagnostics (loopback tests)
cannot be performed on a port
that does not have a small form
factor (SFF) optical transceiver
installed.
Install a transceiver in the port and
perform diagnostics again.
Cannot run diagnostics
while a device is
logged-in to the port.
Port diagnostics (internal loopback
test) cannot be performed on a
port while an attached Fibre
Channel device is logged in.
Ensure the device is logged out and
perform diagnostics again.
Cannot run diagnostics
while a device is
logged-in to the port.
A device is logged in to the port
where a diagnostic test is
attempted.
Log out the device and run the
diagnostic test again.
Cannot save IPL
configuration while
active=saved is
enabled.
You cannot save the IPL file while
the active=saved property is set.
Disable the active=save property of the
FICON Management Server to allow
HAFM to save the IPL file.
Cannot save port
configuration.
The port configuration cannot be
saved at the Element Manager
because the Ethernet link is down
or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Table 12 Element Manager messages (continued)
Message Description Action