HP StorageWorks 2.140 Director Switch - Manual (Page 209)

Director Element Manager user guide 209
No zone selected or
zone no longer exists.
A zoning operation was
attempted without a zone
selected, or the zone selected no
longer exists in the fabric.
Select a zone and try the operation
again.
No zone set active.
A zone set cannot be deactivated
if there are no active zones.
Informational message only—no action
is required.
No zone set selected.
A zoning operation was
attempted without a zone set
selected.
Select a zone set and try the operation
again.
No zone set selected
or zone set no longer
exists.
A zoning operation was
attempted without a zone set
selected, or the zone set you
selected no longer exists in the
fabric.
Select a zone set and try the operation
again.
Only attached nodes
can be displayed in
this mode.
You cannot display unused ports
when adding ports by WWN.
Change the add criteria to Add by Port.
Password and
confirmation don’t
match.
Entries in the password field and
confirmation password field do
not match. The entries are case
sensitive and must be the same.
Enter the password and confirmation
password again.
Remote sessions are
not allowed from this
network address.
Only IP addresses of remote
workstations specified at the
Remote Access dialog box are
allowed to connect to the HAFM
appliance.
Consult with the customer’s network
administrator to determine if the IP
address is to be configured for remote
sessions.
Remote session support
has been disabled.
The connection between the
specified remote workstation and
the HAFM appliance was
disallowed.
Consult with the customer’s network
administrator to determine if the
workstation entry should be modified
at the Remote Access dialog box.
Resource is
unavailable.
The specified operation cannot be
performed because the product is
unavailable.
Verify that the HAFM
appliance-to-product link is up. If the
link is up, the HAFM appliance may be
busy. Try the operation again later.
Route data corrupted.
The information for this route is
corrupt.
Try the operation again. If the problem
persists, contact the next level of
support.
Table 11 HAFM messages (continued)
Message Description Action