Setting up storage for apple mac os x, Iscsi initiator setup for linux – HP MPX200 Multifunction Router User Manual
Page 74
Setting up storage for Apple Mac OS X
1.
In HP P6000 Command View, present the LUNs.
2.
Verify that the P6000 EVA LUNs are presented to the Xtend SAN iSCSI Initiator:
a.
Open the Xtend SAN iSCSI application.
b.
Select the MPX200 target entry under the host name.
c.
Click LUNs.
A list of presented P6000 EVA LUNs is displayed (
).
Figure 70 Presented P6000 EVA LUNs
NOTE:
If no LUNs are displayed, log out and then log in again to the target, or reboot
the system.
3.
Set up the iSCSI drive on the Xtend SAN iSCSI Initiator:
a.
Open Disk Utilities from the Apple Mac OS X Finder Applications list.
b.
Format and partition the P6000 EVA LUN, as needed.
iSCSI initiator setup for Linux
Installing and configuring the SUSE Linux Enterprise 10 iSCSI driver
Configure the initiator using the built-in GUI-based tool or the open-iscsi administration utility
using the iscsiadm command. For detailed command information, see the iscsiadm (8) man
pages.
1.
Modify the initiator name:
# vi /etc/
2.
To configure the initiator and targets, start the iSCSI initiator applet (located in the YaST Control
Center under Network Services), and then set the initiator to start at boot time (
).
74
MPX200 iSCSI configuration rules and guidelines