HP MPX200 Multifunction Router - Manual (Page 218)

Table 34 MPX200 log messages (continued)
(router is target) in subsequent login
PDUs.
iSCSI login PDU was received with an
invalid TSIH value. The TSIH is invalid Error App QLIS_LoginPduContinue: Session
does not exist, invalid TSIH
0x%x
41284
because there is no session with that
TSIH value. This would occur if the
iSCSI initiator attempting the login
failed to used the TSIH value provided
in the target login response PDU
(router is target) in subsequent login
PDUs.
iSCSI login rejected due to a CHAP
authentication error. Error App QLIS_LoginPduContinue: Session
does not exist, invalid TSIH
0x%x
41353
iSCSI login rejected due to a CHAP
key error. Error App QLIS_LoginPduContinue:
Unexpected CHAP key detected
41354
Failed to allocate an object for Set Port
Info IOCTL processing: PortType: 0 = Error App QLBI_SetPortInfo:
QLUT_AllocatePortalObject
41508
FC, 1 = iSCSIPortId: 0 = FC1 or failed (PortType 0x%x, PortId
0x%x) iSCSI1(GE1), 1 = FC2 or iSCSI2
(GE2)
Inquiry command failed. The Inquiry
command was issued by the router as
part of its discovery process. Error App QLBI_GetLunInfo: INQUIRY
failed, TPB status 0x%x
41626
Pass-Through command for Inquiry
command for page 83 failed. The Error App QLBI_GetLunInfo: INQUIRY
failed, TPB status 0x%x
41629
Inquiry command was issued by the
router as part of its discovery process.
Pass-Through command for Read
Capacity command failed. The Read Error App QLBI_Passthru: Invalid data
length %d bytes
41635
Capacity command was issued by the
router as part of its discovery process.
Read Capacity command failed. The
Read Capacity command was issued Error App QLBI_GetLunInfo: INQUIRY
failed, TPB status 0x%x
41636
by the router as part of its discovery
process.
Pass-Through command issued by
management application (such as GUI)
was aborted. Error App QLBI_GetLunInfo: INQUIRY
failed, TPB status 0x%x
41696
Pass-Through command issued by
management application (such as GUI)
failed due to invalid CDB length. Error App QLBI_Passthru: Invalid CDB
length %d bytes
41700
Pass-Through command issued by
management application (such as GUI)
failed due to invalid data length. Error App QLBI_Passthru: Invalid data
length %d bytes
41701
Pass-Through command issued by
management application (such as GUI)
was interrupted or timed out. Error App QLBI_Passthru: Invalid data
length %d bytes
41717
IOCTL operation unsupported.
Operation code provided in log
message. Error App QLBI_Ioctl: ERROR: Operation
(0x%x) not supported in this
mode
41750
Report LUNs command failed. The
Report LUNs command was issued by Error App QLBI_GetLunList: REPORT LUNS
command failed
41768
218 Log messages