HP MPX200 Multifunction Router - Manual (Page 28)

3. Install the rails in the rack.
There are two inner rails and two outer rails. Slide each inner rail into the corresponding outer
rail to create a complete rack rail.
a.
Extend the rack rails to fit the inner dimensions of the rack. The rail flanges on both ends
fit inside the rack.
b. Make sure the inner rail is toward the front of the rack.
c. Fasten the rail flanges to the rack on both ends using two 10-32 x 3/8 in. screws in the
upper and lower holes (
Figure 14 (page 28) ).
Figure 14 Inner rack view
2. Screw, panhead, 10-32 x 3/8 in. 1. Screw, flathead, 6-32 x 1/4 in.
3. Washer
4. Install the chassis in the rack:
a.
Starting from the back of the rack, slide the MPX200 chassis and rail assembly into the
rack rails.
b. Fasten the chassis to the rack using two 10-32 x 3/8 in. screws in the middle hole on
each rail flange (
Figure 15 (page 28) ).
Figure 15 Rear view
1
26588b
1
1. Screws, panhead, 10-32 x 3/8 in.
28 Installing the MPX200