HP MPX200 Multifunction Router - Manual (Page 139)

NOTE: Because the same array port worldwide names can be exposed through both MPX200
blades to the fabric, you must create a new target alias.
5. Using the mpx Manager, start the Target Map Wizard:
a.
On the Select a Target page, expand an array port, and then select a VPGROUP (the
same VPG as when the MPX200 host was created in
Step 2 , “LUN provisioning” (page
42) ) and then click Next.
b. On the Select a Portal page, select an FCoE port, and then click Finish.
c. To view the target mappings:
•
Click the Refresh icon.
•
Under the selected blade, expand the FC Presented Targets and then select a target.
Details appear in the right pane. See Figure 117 (page 139) .
Figure 117 Target mapping
6. Rerun the Target Map Wizard for as many available array ports on each blade.
NOTE: You can cross map ports for redundancy.
Setting up FCoE connectivity to 3PAR arrays 139