HP MPX200 Multifunction Router - Manual (Page 200)

SNMP trap configuration parameters
SNMP trap configuration lets you set up to eight trap destinations. Choose from Trap 1 through
Trap 8 to configure each trap.
Table 33 (page 200) describes the parameters for configuring an
SNMP trap.
Table 33 SNMP trap configuration parameters
Description Parameter
Enables or disables trap n. If disabled, the trap is not configured. Trap n enabled
1
Specifies the IP address to which the SNMP traps are sent. A maximum of eight trap addresses
are supported. The default address for traps is 0.0.0.0. Trap address
Port number on which the trap is sent. The default is 162. If the trap destination is not enabled,
this value is 0 (zero). Most SNMP managers and management software listen on this port
for SNMP traps. Trap port
1
Specifies the SNMP version (1 or 2) with which to format traps. Trap version
1 Trap address (other than 0.0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2 have
the same address, they must have different port values. Similarly, if trap 1 and trap 2 have the same port value, they
must have different addresses.
Management Information Base
This section describes the QLogic MIB.
Network port table
The network port table contains a list of network ports that are operational on the router. The entries
in this table include the management port (labeled MGMT) and the GbE ports (labeled GE1 and
GE2).
qsrNwPortTable
SEQUENCE OF QsrNwPortEntry Syntax
Not accessible Access
Entries in this table include the management port, and the iSCSI ports on the router. Description
qsrNwPortEntry
QsrNwPortEntry Syntax
Not accessible Access
Each entry (row) contains information about a specific network port. Description
A network port entry consists of the following sequence of objects:
QsrPortRole qsrNwPortRole
unsigned32 qsrNwPortIndex
INTEGER qsrNwPortAddressMode
InetAddressType qsrIPAddressType
InetAddress qsrIPAddress
InetAddress qsrNetMask
InetAddress qsrGateway
MacAddress qsrMacAddress
200 Simple Network Management Protocol setup