HP MPX200 Multifunction Router User Manual

Page 193

Admin session

Authority

setup
start

wanlinktest

Syntax

show
stop

Configures the WAN link test parameters on the server side
of the WAN link.

setup

Keywords

Begins running the WAN link test on the client side of the
WAN link.

start

Displays the outcome of the WAN link test on the client or
the status and port number of the server if running.

show

Terminates running the WAN link test.

stop

NOTE:

When setting up or starting the test, ensure that the Gige Port parameter specifies the

same port number as the WAN link test server and the client.

Example 1:
The following example illustrates the use of the wanlinktest setup command.

MPX200 <2>(admin) #> wanlinktest setup

A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.

Gige Port (0=Mgmt, 1=GE1, 2=GE2, ...) [Mgmt ] 1
Is Local IP already configured (y=yes, n=no) [y ] N
Local IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.1
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway [0.0.0.0 ]
MTU (Min=582, Max=9000) [1500 ]
VLAN (0=Enable, 1=Disable) [1=Disable]
Server Port to listen On (3225 FCIP/3260 iSCSI)[ ] 3260

Started iperf Server on port 1 (socket 3260) sucessfully..!

Example 2:
The following example illustrates the use of the wanlinktest start command.

MPX200 <1>(admin) #> wanlinktest start

Gige Port (0=Mgmt, 1=GE1, 2=GE2, ...) [Mgmt ] 1
Is Local IP already configured (y=yes, n=no) [y ] N
Local IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.2
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway [0.0.0.0 ]
MTU (Min=582, Max=9000) [1500 ]
VLAN (0=Enable, 1=Disable) [1=Disable]
Test Duration in Minutes (multiples of 5) [10 ]
Server Port to connect to 3225 FCIP/3260 iSCSI)[ ] 3260

Checking whether resources are available to start WAN LINK TEST

Commands

193