HP MPX200 Multifunction Router - Manual (Page 169)

Sets the Internet Simple Name Service (iSNS)
parameters. See
“set iSNS command” (page 172) .
isns
Sets the management port parameters. See “set mgmt
command” (page 173) .
mgmt
Sets the NTP parameters. See “set NTP
command” (page 173) .
ntp
Configures CLI properties for the blade. See “set
properties command” (page 174) .
properties
Sets the Simple Network Management Protocol (SNMP)
parameters, such as the symbolic name and log level.
See
“set SNMP command” (page 174) .
snmp
Sets system parameters, such as the symbolic name
and log level. See
“set system command” (page 175) .
system
Sets VPGs on the blade. See “set VPGroups
command” (page 175) .
vpgroups [vpgroup index]
Set alias
Assigns an alias name to a presented iSCSI target.
Admin session Authority
set alias Syntax
Example:
MPX200 <2> (admin) #> set alias
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index (WWNN,WWPN/iSCSI Name)
----- ----------------------
0 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.01.50001fe150070ce9
1 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.02.50001fe150070ce9
2 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.03.50001fe150070ce9
3 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.04.50001fe150070ce9
4 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.01.50001fe150070cec
5 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.02.50001fe150070cec
6 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.03.50001fe150070cec
7 iqn.1986-03.com.hp:fcgw.mpx200.0834e00025.b1.04.50001fe150070cec
Please select a iSCSI node from the list above ('q' to quit): 0
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Set CHAP
Configures the CHAP parameters.
Admin session Authority
set chap Syntax
Example:
MPX200 <1>(admin) #> set chap
A list of attributes with formatting and current values will follow. Enter a
new value or simply press the ENTER key to accept the current value. If you
Commands 169